CALL US TOLL FREE | 9am-7pm EST | M-F
LOCATIONS ACROSS THE NATION | TO SERVE THE ENTIRE COUNTRY
Leading Automotive Equipment Dealer Since 1987
ABOUT
CALL US TOLL FREE | 9am-7pm EST | M-F
LOCATIONS ACROSS THE NATION | TO SERVE THE ENTIRE COUNTRY
Leading Automotive Equipment Dealer Since 1987
ABOUT
Atlas® Platinum ATTD-12ASL-Combo
Important Information! Read To Avoid Damaging Your Lift Click Here
Atlas® Asian partner developed this lift in a joint venture with one of the most prestigious Italian lift manufacturers. The combination of the Italian engineering and design coupled with the low cost of the Asian labor has resulted in an alignment lift that is equal to or better than similar big name lift brands costing two and three times as much money.
The Atlas® alignment lift has a lifting height of over seven feet so that it may be floor mounted or recessed if the customer decides on a flush mount installation. The full frame under the scissor lift provides for maximum stability.
All Atlas® alignment scissor lifts can be surface mounted or flush mounted. Each lift comes with approach ramps for the floor mounted application or an optional set of ramps if the customer decides to flush mount the lift. Check the technical specifications to better understand how the extra high lifting height allows the Atlas® 12K alignment scissor to be flush mounted and still offer plenty of room under the runways to properly access the underside of the vehicle.
The extra long 53" long approach ramps make it easy to load low riding vehicles.
The Atlas® RJ-6 rolling jack is the perfect accessory for either the Atlas® 12 AWFSL or Atlas® 12 ASL alignment racks. The Atlas® RJ-6 (6,000 lbs. capacity) air/hydraulic rolling jack may also be used on competitive scissor lifts and four post lifts that have welded rails on the inside of the runways. Please contact our sales team to determine if the Atlas® RJ-6 rolling jack will fit your lift.
The "wheels free" system that is built into many of the Atlas® scissor lifts is designed to reach and lift most vehicles. Some customers like to use the rolling jacks to lift either the front or the rear of the vehicle at one time.
The Atlas® RJ-6000 (Air/Hydraulic) comes standard with a set of peg style truck adapters which increases the lifting height of the lift pads. These truck adapters will allow the Atlas® RJ-6000 rolling hydraulic jack to raise most pick up and larger trucks that will sit higher than the average passenger car.
Important: The Atlas® RJ-6 is designed and engineered to operate on "delivered" air pressure of between 70-105 PSI. If you exceed 105 PSI, you may damage your jack. For more information on the recommended operating air pressure of the Atlas® RJ-6 Click Here.
